Re: problem with installing patches (74 Views)
Reply
Super Advisor
Tarek
Posts: 275
Registered: ‎12-19-2000
Message 1 of 5 (74 Views)
Accepted Solution

problem with installing patches

I'm trying to install some patches: for ex. PHCO_22924 - PHSS_19379 - PHSS_21971.....but having problems during swinstall, an error message appear:
"name_ws:/patch/PHSS_19739": An I/O error occurred while performing this task.
First I thought the patches were downloaded bad, i tried the second download but during install the same messages appears.
Hope someone can help me.
Please use plain text.
Trusted Contributor
Pete Ellis
Posts: 40
Registered: ‎05-07-2000
Message 2 of 5 (74 Views)

Re: problem with installing patches

The patch names should have .depot on the end, have you run sh to unpack the patch?

Pete
Please use plain text.
Trusted Contributor
Thomas Kollig
Posts: 60
Registered: ‎12-21-2000
Message 3 of 5 (74 Views)

Re: problem with installing patches

Hi!

Perhaps you have gezipped files. Rename them (add .gz) and use gunzip.

Bye,

Thomas
Please use plain text.
Super Advisor
Tarek
Posts: 275
Registered: ‎12-19-2000
Message 4 of 5 (74 Views)

Re: problem with installing patches

Thanks very much!!! That was a problem...I'm new and i'm trying to learn, so every time i download patch i have to run sh...
Thanks again
Please use plain text.
Honored Contributor
Dan Hetzel
Posts: 926
Registered: ‎07-25-2000
Message 5 of 5 (74 Views)

Re: problem with installing patches

Hi Tarek,

When you download a patch from HP ftp server, it comes as a text file.

This text file is a "shell archive" that need to be extracted using the following command:
sh PH??_?????

Make sure that you have the correct format if you are downloading on a PC as windows uses
pairs to delimit lines while Unix only uses

If you transfer from HP ftp server to a PC, use the binary mode when ftping to your HP Box.

If you use 'vi' in the patch file and see a '^M' at the end of every line, then you know it's the wrong format. Use 'dos2unix' to convert your file if it's the case.

Once extracted (with 'sh PH??_????') it should leave you 2 files, one ending in '.depot' and one ending in '.text'.
The first oue should be used as source for your swinstall command.

Best regards,

Dan
Everybody knows at least one thing worth sharing -- mailto:dan.hetzel@wildcroft.com
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation