ndd param change (558 Views)
Reply
Frequent Advisor
Kuntal Gupta
Posts: 50
Registered: ‎08-04-2010
Message 1 of 3 (558 Views)
Accepted Solution

ndd param change

Dear HPUX lovers,

 

OS: HP UX 11.31 V3

 

I want to set "ip_send_source_quench" to  0.

 

I think the command for this is:

 

#ndd -set /dev/ip ip_send_source_quench 0

 

Is the the change will be permanent?

 

To make the change permanent waht should be done?

 

nddconf does contain any entry for ip_send_source_quench.

 

ndd -f shows the param.

 

Regards...

 

Kuntal

Please use plain text.
Honored Contributor
Matti_Kurkela
Posts: 6,271
Registered: ‎12-02-2001
Message 2 of 3 (553 Views)

Re: ndd param change

If you just change the setting with the ndd command, the change will not be permanent: when the system is rebooted, the default value will be used again.

 

To make it permanent, you must add the setting to /etc/rc.config.d/nddconf in the form of three lines:

TRANSPORT_NAME[0]=ip
NDD_NAME[0]=ip_send_source_quench
NDD_VALUE[0]=0

 Note: if the /etc/rc.config.d/nddconf file already has some other settings configured, you should replace [0] in the above lines with the number of the highest-numbered existing setting +1.

MK
Please use plain text.
Frequent Advisor
Kuntal Gupta
Posts: 50
Registered: ‎08-04-2010
Message 3 of 3 (538 Views)

Re: ndd param change

Thanks MK, it worked.

 

Regards...

 

Kuntal

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation