VxVM 3.5 will not recognise vpath devices (142 Views)
Reply
Regular Advisor
Shane Russell
Posts: 98
Registered: ‎11-07-2004
Message 1 of 1 (142 Views)

VxVM 3.5 will not recognise vpath devices

[ Edited ]

Hi I have a 2-node VCS 3.5 cluster. The nodes are running HP-UX 11.11 and connected to an EMC DMX using PowerPath 5.0.1 for load-balancing & multipathing. I need to virtualise the DMX behind an IBM SVC to facilitate a migration. To do this I need to un-install PowerPath and install IBM SDD ... which I have done. IBM SDD creates the vpath pseudo devices fine but the vxdisk list reports all paths and not just the controlling device. Any advice? NOTES : I can't use VxVM DMP because the vxlibibmsvc.so library is not available for 3.5 regards Shane Russell

 

 

P.S. This thread has been moved from HP9000 to HP-UX > LVM and VxVM. - Hp Forum Moderator

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation