PX_NOPV on lvdisplay (316 Views)
Reply
Frequent Advisor
Roberto Volsa
Posts: 142
Registered: ‎03-12-2000
Message 1 of 2 (316 Views)

PX_NOPV on lvdisplay

Hi peer
i lvextended an lvol (from a PVG, mirroring the lvol to another PVG).
the command is still in execution but the lvdisplay gives PX_NOPV oon description of disks of mirrored copy of ALL physical extent.
Any suggestion

The VG is a cluster VG, and anoter hosts as a different pvg definition of such vg.

Thanks and regards
RV
Honored Contributor
VK2COT
Posts: 921
Registered: ‎01-17-2006
Message 2 of 2 (316 Views)

Re: PX_NOPV on lvdisplay

Hello,

It is obvious that some command failure has
left the logical volume in state where extents are not assigned to a physical volume correctly.

There is a nice Technical Knowledge Base document ULVMKBRC00009684 that describes
your problem .

Several possibilities:

a) Check your patches. For example,
PHKL_31500 addresses it for HP-UX 11.23.

PHKL_35970 for HP-UX 11.11.

b) Reduce the logical volume and "rebuild
the mirroring"

lvreduce -m 0 ....

Regards,

VK2COT
VK2COT - Dusan Baljevic
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.