ospf point-to-point (174 Views)
Reply
Occasional Visitor
maitmoulay
Posts: 3
Registered: ‎02-22-2013
Message 1 of 2 (174 Views)

ospf point-to-point

Hello,

 

I would like to configure ospf  between switch HP (5412 - 3500 ) and I want to use point to point mode, as with the Cisco command "ip ospf network point-to-point", there is the equivalence of this command on HP?

 

thank you

 

Mustapha

Honored Contributor
Peter_Debruyne
Posts: 328
Registered: ‎03-21-2011
Message 2 of 2 (161 Views)

Re: ospf point-to-point

Hi,

 

this is only supported on comware based switches, not on the provision switches (like 3500/5400/8200),

 

Best regards,Peter

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.