RX2620 firmware hang (1789 Views)
Reply
Occasional Visitor
Serg G
Posts: 1
Registered: ‎04-28-2008
Message 1 of 3 (1,789 Views)

RX2620 firmware hang

Display panel returns LED2 RED and SYSTEM LED Flashing RED . In troubleshouting guide it's firmware hang.
How can I fix/repair firmware on Integrity rx2620 Server?
Managment Console doesn't working.
Occasional Visitor
j_at_ray
Posts: 1
Registered: ‎07-12-2010
Message 2 of 3 (1,772 Views)

Re: RX2620 firmware hang

I've seen this problem a great many times.  Once you get the machine booting, update the EFI, System, BMC firmware to the latest available (remember to read the installation notes, especially the requirements).  I've had luck clearing the problem by doing some of the following:

 

1.  Voodoo Raindance: Boot the server.  As the LED's start flashing 1 through 4, remove the power cord.  With the power cord out, tap the power button.  Now replace the power cord, and allow the server to come up to standby.  Attempt to power the machine on again.  If that doesn't work, repeat pulling power during the flashing LED stage 2 or more times.

 

2. Re-seating the system memory has helped when 1 didn't.

 

Good luck.

 

 

Acclaimed Contributor
Dennis Handly
Posts: 25,188
Registered: ‎03-06-2006
Message 3 of 3 (1,429 Views)

Re: RX2620 firmware hang

A better forum for Integrity servers is the ITRC forum: Servers > Integrity Servers:
http://forums.itrc.hp.com/service/forums/categoryhome.do?categoryId=275

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.