11-14-2013 01:24 PM
I am setting up an rx8640 and when powering it on, the MP boot stops at the acpid check. Not sure what to look at for the problem.
Here is the out from the serial console, it sits at the end and does not move past it:
Primary Bootloader 1.0.0
(c) Copyright 2003-2005 Hewlett-Packard Co.
Testing upload SDRAM ... Passed
Checking Secondary Boot Loader .. Passed
Booting loaded image...
Secondary Bootloader 2.0.0
Testing Application Memory............. Passed
Testing UART1... Passed
Copying image to RAM...Done
initFailedOverState: hwRev: 14, genStat: 5, slotStat e
Attaching interface lo0...done
Adding 13711 symbols for standalone.
MP Master/Slave failover Daemon OK
Master Slave failover is enabled. OK
Hardware Manager phase 0 OK
Management Fabric OK
[Instance is a master running on a 4 slot cabinet]
Persistant Data Storage repository API OK
Loading Persistent Parameters OK
Diagnostics daemon OK
Hardware Manager phase 1 OK
eventID handler OK
11-14-2013 01:52 PM
Well, ACPI is a type of power/environmental specification, so I would gather that ACPID is a daemon or process that controls this spec. In these servers ACPI resides within the MP, so you may have a faulty Core IO board. If you have two of them in the server, try swapping them around.