Re: rx8640 MP boot stops at acpid (281 Views)
Reply
Occasional Contributor
Jessie Loch
Posts: 5
Registered: ‎02-25-2011
Message 1 of 2 (291 Views)

rx8640 MP boot stops at acpid

I am setting up an rx8640 and when powering it on, the MP boot stops at the acpid check. Not sure what to look at for the problem.

 

Here is the out from the serial console, it sits at the end and does not move past it:

 

 

Primary Bootloader 1.0.0
(c) Copyright 2003-2005 Hewlett-Packard Co.
Testing upload SDRAM ... Passed
Checking Secondary Boot Loader .. Passed

Booting loaded image...
��
Secondary Bootloader 2.0.0

Testing Application Memory............. Passed

Testing UART1... Passed


Copying image to RAM...Done

initFailedOverState: hwRev: 14, genStat: 5, slotStat e
Attaching interface lo0...done

Adding 13711 symbols for standalone.

MP Master/Slave failover Daemon OK
Master Slave failover is enabled. OK
Hardware Manager phase 0 OK
Communications/Protocol Manager:
IP OK
ARP OK
RPC OK
ACPI OK
IPMI OK
bUSBoy OK
Management Fabric OK

[Instance is a master running on a 4 slot cabinet]

Persistant Data Storage repository API OK
Loading Persistent Parameters OK
Diagnostics daemon OK
Hardware Manager phase 1 OK
CLU OK
snmpd OK
inetd OK
Ipmid OK
eventID handler OK
Gldb OK
Acpid

Honored Contributor
Robert_Jewell
Posts: 1,238
Registered: ‎06-26-2001
Message 2 of 2 (281 Views)

Re: rx8640 MP boot stops at acpid

Well, ACPI is a type of power/environmental specification, so I would gather that ACPID is a daemon or process that controls this spec.  In these servers ACPI resides within the MP, so you may have a faulty Core IO board.   If you have two of them in the server, try swapping them around.

 

-Bob

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.