01-22-2012 03:15 AM
I am trying to its install hpux 11iv3 in rx2600 . Currently it is running with 11iv2 .But when I go to efi shell , I am not able to find the DVD mapping in EFi shell . I tried with reconnect -r and map -r .. still is not showing anything . i could see that DVD is working fine . Because I was able to install some patch from DVD drive . Please some one help me to fix the issue
In EFI shell I can see only below entries , at the same time ioscan -e command show the DVD output from OS
ioscan -e output
0/0/2/0.0.0.0 disk TEAC DV-28E-B
Scsi(Pun0,Lun0) HP 36.4GST336753LC HPC3 (320 MBytes/sec)
Scsi(Pun1,Lun0) HP 36.4GST336753LC HPC3 (320 MBytes/sec)
Scsi(Pun2,Lun0) HP 73.4GST373453LC HPC3 (320 MBytes/sec)
ReconnectController(0,0,0) : Status = Success
fs0:\> map -r
Device mapping table
fs0 : Acpi(HWP0002,100)/Pci(1|1)/Scsi(Pun2,Lun0)/HD(Part
blk0 : Acpi(HWP0002,100)/Pci(1|0)/Scsi(Pun0,Lun0)
blk1 : Acpi(HWP0002,100)/Pci(1|0)/Scsi(Pun1,Lun0)
blk2 : Acpi(HWP0002,100)/Pci(1|1)/Scsi(Pun2,Lun0)
blk3 : Acpi(HWP0002,100)/Pci(1|1)/Scsi(Pun2,Lun0)/HD(Part
blk4 : Acpi(HWP0002,100)/Pci(1|1)/Scsi(Pun2,Lun0)/HD(Part
01-22-2012 08:04 PM
Hi All ,
I am not sure what I did exactly , But Now its showing only the cdrom
i issued drvcfg -s and enabled all primary master , sleve and secondary master and sleve ..and then I stopped the controller . after i issued map -r .. then I could find the cdrom .. but its not showing any disk ..
is this something related to raid controller ?
01-23-2012 03:29 AM
Could you please confirm, what is the release of the HPUX 11i v3.
Is it a ISO image or HP media
Please try to use the latest release of the HPUX11i v3 DVD media from HP.
I hope the new media will resolve your issue.
HP Guided Troubleshooting - www.hp.com/support/hpgt