System abort 55 from subsystem 146 (360 Views)
Reply
Advisor
David Chau_2
Posts: 28
Registered: ‎10-10-2002
Message 1 of 4 (360 Views)
Accepted Solution

System abort 55 from subsystem 146

Hi, I have a system disk crashed and am trying to re-install MPE from SLT tape created from the same system on the new disk with the same model. After booting from tape and run install, the process halted with: System abort 55 from sub system 146. FLT 0137 BF07... Any help is much appreciated. Thank you in advance.
Honored Contributor
Kwan Fong, Emile
Posts: 1,162
Registered: ‎07-10-2000
Message 2 of 4 (360 Views)

Re: System abort 55 from subsystem 146

Hello David,

System Abort #55 means "An error occurred in CONFIGURE_DEVICE".

Subsystem is "Genesis".

Based to the abort number, it looks like the boot process cannot talk to the new disk. make sure the new disk matches the configuration (hardware path, sysgen ID)that is on the CSLT tape.
King is the customer!
Advisor
David Chau_2
Posts: 28
Registered: ‎10-10-2002
Message 3 of 4 (360 Views)

Re: System abort 55 from subsystem 146

Thanks for the reply. It's not only the problem with the SCSI disk but the SCSI controller also went bad. Thanks again.
Advisor
David Chau_2
Posts: 28
Registered: ‎10-10-2002
Message 4 of 4 (360 Views)

Re: System abort 55 from subsystem 146

Thanks for the reply. I found out that not only the SCSI disk was bad but the SCSI controller went bad too. Thanks again.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.