BuldAcct capabilities (241 Views)
Reply
Frequent Advisor
j kubler
Posts: 130
Registered: ‎11-03-2003
Message 1 of 2 (241 Views)

BuldAcct capabilities

I need to rebuild and environment from one HP 3000 system to another. Trouble is, we want to have groups from the same account end up on different user volumes. So one group from the CHC account needs to go to MEDADV_1 while another from the same account needs to got to MEDADV_2. However, when you try to enter a group and account like FILEMOR.CHC%VSACCT=MEDADV_1 it says that the ACCOUNT NAME IS GREATER THAN 8 Characters. Is there a way to do this using BULDACCT?
What would be the syntax?
Other suggestions?
Trusted Contributor
Denis St-Amand
Posts: 89
Registered: ‎02-27-1997
Message 2 of 2 (241 Views)

Re: BuldAcct capabilities

BULDACCT VSACCT option permits to migrate *all* groups from supplied account list. It expects account names, not group names.

You'll need to migrate most groups to one volume set and then manually migrate others to the other one.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.