Status untouched (241 Views)
Reply
Honored Contributor
Hakki Aydin Ucar
Posts: 1,314
Registered: ‎08-16-2006
Message 1 of 4 (241 Views)

Status untouched

while I start to backup via ignite-ux some Disk/VG stated as untouched , what does untouched mean here ? And do I have to include Untouched VG along with In Full VG during backup setup ?

Honored Contributor
Patrick Wallek
Posts: 13,784
Registered: ‎06-21-2000
Message 2 of 4 (235 Views)

Re: Status untouched

>>...some Disk/VG stated as untouched, ...

 

Where are you seeing this?  Is it in the output from the Ignite backup?  If so, attaching the Ignite log file to this thread would be very helpful.

 

 

Honored Contributor
Hakki Aydin Ucar
Posts: 1,314
Registered: ‎08-16-2006
Message 3 of 4 (219 Views)

Re: Status untouched

it was ignite-ux GUI , and exact step is to create tape recovery setup:

I opened up ignite-ux GUI > select server > Create Tape Recovery Archive > Choose a Tape Driver > Recovery Archive contents left side under select disk/vg ..

when I try to select Untouched status vg ,it warned me status untouched because there are exclude entries..

Could you please check the images I attached.

Acclaimed Contributor
Torsten.
Posts: 23,443
Registered: ‎10-02-2001
Message 4 of 4 (215 Views)

Re: Status untouched

Ignite should be used for vg00.

 

Better use other backup tools for your data.

 

IMHO you get the message because of a conflict in include/exclude statements.


Hope this helps!
Regards
Torsten.

__________________________________________________

There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________

No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.