Restoring from Ignite Server (771 Views)
Reply
Super Advisor
Darren Etheridge_2
Posts: 314
Registered: ‎08-05-1999
Message 1 of 3 (771 Views)

Restoring from Ignite Server

I have an Ignite server running on a PA-RISC machine running 11.23

 

The client server that I backup to the Ignite Server is a Integrity BL870i2 running 11.31 and backs up to the Ignite server fine.

 

Now my key question is how in the world do I get the BL870i2 to boot from the ignite server (running 11.23)?

 

I have followed all the instructions setting up the /etc/exports:

/var/opt/ignite/clients -anon=2
/var/opt/ignite/recovery/archives/hal -anon=2,access=hal
/var/opt/ignite/archives/Rel_B.11.31 ro ""

 

but I have no idea what to do from here.  it seems when trying to boot, I dont' get the option to seach for a boot item (like 11.23).

 

I have read most if not all the documentation but no luck with the setup.

 

Any help would be appreciated! 

 

D

HP Pro
pradeep m
Posts: 154
Registered: ‎12-08-2010
Message 2 of 3 (765 Views)

Re: Restoring from Ignite Server

[ Edited ]

Hi,

 

Performing Ignite-UX server backup wouldn't require much configuration on the Ignite-UX server side. However you would need to configure the Ignite-UX Server inorder to restore the backup on to PA-RISC or Itanium client systems. 

 

After configuring the Ignite-UX Server, if the client system is down, boot the cient and interept the boot sequence at EFI and use "lanboot" or lanboot with dprofile command to restore from server.

If the client is up and running, then you can use the "bootsys" command from Ignite-UX server / client to initiate the system recovery. 

 

For detailed information, please refer the HP Ignite-UX Guided Troubleshooting for step by step instructions to configure Ignite-UX Server and methods to restore the PA-RISC or Itanium based client systems from Ignite-UX Server.

 

Click here to access HP Ignite-UX Guided Troubleshooting.

 

For Ignite-UX Server Side Configuration: From above web link, choose "Configuration / How-To Guide" option -->choose Ignite-UX Server Side Configuration

 

For Ignite-UX Network Recovery: From above web link, choose "Configuration / How-To Guide" option -->choose "System Recovery" --> Choose "Ignite-UX Network Recovery". 

 

Hope this information helps.

Regards,
Pradeep

I am an HP Employee
Frequent Advisor
Shane Seymour
Posts: 61
Registered: ‎11-28-2007
Message 3 of 3 (751 Views)

Re: Restoring from Ignite Server

The Ignite admin guide has all of the information you need. If you don't want to configure DHCP/PXE on the Ignite server (assuming it's on the same subnet) to enable network boot use dbprofiles (there's information on how to use that command from the EFI shell in the admin guide) with an i2 blade.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.