Re: Ignite not recreating modem device files (78 Views)
Reply
Occasional Advisor
Susan Harris
Posts: 26
Registered: ‎08-10-2000
Message 1 of 3 (78 Views)

Ignite not recreating modem device files

I re-Ignited 5 servers a few weeks back and all went fine. We are using Predictive support on these servers which will dial out via modem to report any errors. Last week I found out that Predictive hasn't been running on any of these servers since they were Ignited. I used SAM to 'see' the modem and it wasn't found. I had to reinstall it. Has anyone run into the same problem? I don't recall the version of Ignite I used when I had this problem, and I have since upgraded to B.2.6.358....
Sue
Please use plain text.
Respected Contributor
Herve BRANGIER
Posts: 215
Registered: ‎07-06-2000
Message 2 of 3 (78 Views)

Re: Ignite not recreating modem device files

I use X25 cards and have a similar problem :
x25 is badly configured after restoration
with Ignite. We don't know why and have to reinstall this part.

Herve
Please use plain text.
Honored Contributor
Darrel Louis
Posts: 856
Registered: ‎11-27-2000
Message 3 of 3 (78 Views)

Re: Ignite not recreating modem device files

Susan,

check in the following file:
/opt/ignite/data/scripts/os_arch_post_l

# The ioconfig files are handled by hw_instance_num config file
# keyword, however IUX can only preserve instance numbers for
# drivers that are in the INSTALL kernel. If this is a problem,
# then you can uncomment the next two lines. However doing this
# can cause some problems when cloning to different hardware.

This could be a reason???
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation