Re: Ignite-UX on 11iv3 Itanium host - make_tape_recovery (149 Views)
Reply
Super Advisor
Tom Haddad
Posts: 330
Registered: ‎02-27-2007
Message 1 of 5 (149 Views)
Accepted Solution

Ignite-UX on 11iv3 Itanium host - make_tape_recovery

I run make_tape_recovery process on all my hosts against the root volume group. On one of my hosts the process ran fully but at the end reported this..
THE FOLLOWING LINE(S) HAD TOO FEW/INCORECT ENTRIES:
LINE 5 tmp/ 40770 1299092416 96 0 NA 3 0x52b 0x40000004

Then it says archive created succcessully.
Can anyone shed some insight on the the message above. Is 0x40 the minor number?
Acclaimed Contributor
Dennis Handly
Posts: 25,063
Registered: ‎03-06-2006
Message 2 of 5 (149 Views)

Re: Ignite-UX on 11iv3 Itanium host - make_tape_recovery

>LINE 5 tmp/ 40770 1299092416 96 0 NA 3 0x52b 0x40000004

This typically occurs because the filename has spaces or other junk in it. The "5" above is the length of the filename and I'm not sure how that "/" got there.
Acclaimed Contributor
Dennis Handly
Posts: 25,063
Registered: ‎03-06-2006
Message 3 of 5 (149 Views)

Re: Ignite-UX on 11iv3 Itanium host - make_tape_recovery

[ Edited ]
Super Advisor
Tom Haddad
Posts: 330
Registered: ‎02-27-2007
Message 4 of 5 (149 Views)

Re: Ignite-UX on 11iv3 Itanium host - make_tape_recovery

Thanks for the helpful info I was able to locate ths issue (filename). !!!
Super Advisor
Tom Haddad
Posts: 330
Registered: ‎02-27-2007
Message 5 of 5 (149 Views)

Re: Ignite-UX on 11iv3 Itanium host - make_tape_recovery

I was able to locate the problem (filename) and remove it..thanks!
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.