Ignite Rebuild Kernel (89 Views)
Occasional Contributor
Posts: 3
Registered: ‎07-04-2011
Message 1 of 1 (89 Views)

Ignite Rebuild Kernel



I am igniting source ignite image on different hardware ( both model are rp8420 ) as part of hardware change.


I have  added couple of drivers ( scsi320 , IEther-00 , which are created using make_config ) along with source image image  for hardware compatiable on new server.


Installation get successful.  Additional driver also get installed as part of installation.


Though  I can't see kernel get rebuild during this process.  This causing  server panic during boot.


Install log  shows



       * Build_Kernel:  Begin


NOTE:    Since the /stand/vmunix kernel is already in place, the kernel will

         not be re-built. Note that no mod_kernel directives will be processed.



       * Build_Kernel:  Complete




       * Boot_From_Client_Disk:  Begin.



Does any way to rebuild kernel as part ignite installation when additional drivers also installed.




Abhijeet Durugkar

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.