I want to build a Ignite server for HP UX Version 11.V3 system. (215 Views)
Reply
Occasional Contributor
paramanandam jala
Posts: 12
Registered: ‎05-25-2010
Message 1 of 3 (215 Views)

I want to build a Ignite server for HP UX Version 11.V3 system.

[ Edited ]

I want to build a Ignite server for HP UX Version 11.V3  system. Can anynody share the step by step setup guide. I don't need any HP Official doc which I already have.

Pl. help us configure the Ignite Server.   regards,

Anand, Microcare

Please use plain text.
Valued Contributor
Ralf Seefeldt
Posts: 166
Registered: ‎04-02-2001
Message 2 of 3 (213 Views)

Re: I want to build a Ignite server for HP UX Version 11.V3 system.

The Document, you added, should suffice. I succeeded with these steps.
Be sure to export your ignite directory to everyone writable.
The IP-Range for ignite must be reachable without crossing a router.

Do you have any errormessages or are you still in the state of planing?

Bye
Ralf
Please use plain text.
Frequent Advisor
Chirag Parikh
Posts: 51
Registered: ‎11-06-2007
Message 3 of 3 (189 Views)

Re: I want to build a Ignite server for HP UX Version 11.V3 system.

Hi,

 

Find the summarized steps in short.

 

1.mkdir /var/opt/ignite/recovery
2.create a filesystem of req size and mount on /var/opt/ignite/recovery
3.cd /var/opt/ignite/recovery
mkdir archives
4.chown to bin:bin
5.run /opt/ignite/bin/ignite
it will display a window
6.select server setup
7.configure booting ip address --- next
8.use unsed ip in ur nw
9.selct skip dhcp setup -- next--ok
10.selct skip depot config ---next
11 yes =------ finish
12.in /etc/rc.config.d/nfsconf

 

Thanks & Regards,

Chirag Parikh

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation