Re: HP Proliant System Management E-mail notification (425 Views)
Reply
Occasional Contributor
superflysy
Posts: 7
Registered: ‎08-12-2006
Message 1 of 5 (522 Views)

HP Proliant System Management E-mail notification

Hi everyone

 

Can anyone help me with this little issue i have

 

I basically want to setup e-mail notifications via the HP System Management software which is installed on a Proliant ML350e Gen8 server . These notifications will alert me should the server have any issues.

 

I've setup the e-mail address within the Event Notifier Config and now just want to test this, but how?

 

Thanks

Simon

HP Pro
scharchouf
Posts: 296
Registered: ‎03-07-2013
Message 2 of 5 (495 Views)

Re: HP Proliant System Management E-mail notification

try to send test email from SMH, hardware change Like deplug HDD, firmware for controller card...

I am an HP employee
Was the post useful? Click on the white KUDOS! Star
Honored Contributor
Bart_Heungens
Posts: 696
Registered: ‎10-26-2005
Message 3 of 5 (456 Views)

Re: HP Proliant System Management E-mail notification

[ Edited ]

From Gen8 servers on, you don't really need the SMH and Insight agents anymore (you can go for Agentless Management Service). And definitely not for sending emails.

 

You can do this now directly from the ILO4 Management Engine.

Log on to the ILO, go to Administration - Management and then choose AlertMail...

 

 

 

Kr,

Bart

--------------------------------------------------------------------------------
If my post was useful, clik on my KUDOS! "White Star" !
My blog: http://blog.bitcon.be
Occasional Contributor
superflysy
Posts: 7
Registered: ‎08-12-2006
Message 4 of 5 (426 Views)

Re: HP Proliant System Management E-mail notification

Hi Scharchouf

 

Unfortunately the server is 2 hours away so i cannot remove or turn off the server to test it. Can you suggest anything that i can do remotely?

 

Thanks

Simon         

Occasional Contributor
superflysy
Posts: 7
Registered: ‎08-12-2006
Message 5 of 5 (425 Views)

Re: HP Proliant System Management E-mail notification

Hi Bart

 

I've tried to open the ILO 4 from the SMH but it just takes me to 0.0.0.0 and says page cannot be displayed. The server is a couple of hours away so it's not an easy bit of hardware to administer!

 

Any suggestions?

 

Thanks

Simon

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.