empty DDMI graphs (555 Views)
Posts: 27
Registered: ‎09-01-2011
Message 1 of 2 (555 Views)
Accepted Solution

empty DDMI graphs

Hi hi,

I have DDMI 9.3 that discovered about 500 devices.

In my first web page I have always empty graphs, why?


Best regards


kudo available

Frequent Advisor
Posts: 46
Registered: ‎08-15-2011
Message 2 of 2 (552 Views)

Re: empty DDMI graphs


 the graphs on the DDMI server home page show percentage of on-time scanned devices >80; when this percentage drops lower than 80, the graphs are empty.

 there is an article in the HP Knowlege base on this as well;


You should probably check the status following report:

Server > Status > Device status > Active devices; then you can apply a filter on Scanning status and check how many devices were scanned on time and how many are behind for a long period of time.



The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.