Re: First installation of IMC 5.1 and can't login in the initial page (471 Views)
Reply
Occasional Contributor
akapousi
Posts: 5
Registered: ‎01-18-2013
Message 1 of 4 (490 Views)

First installation of IMC 5.1 and can't login in the initial page

I just installed IMC 5.1 and I tried to login on the web page for the first time, but login is not working. I tried "admin" in both Operator and password, but is not working. I checked and the services and all are up and running. Any suggestions?

 

Thanks,

 

Agelos

Valued Contributor
John_Katzmaier
Posts: 72
Registered: ‎08-23-2010
Message 2 of 4 (484 Views)

Re: First installation of IMC 5.1 and can't login in the initial page

Hi,

 

The default login for IMC is admin with a password of admin

 

I suggest using either Firefox or Internet Explorer as your browser and adding the IP address of the IMC server as a Trusted Site in Internet Explorer. It also better to connect to the IMC server from a different system than the IMC server.

Honored Contributor
LindsayHill
Posts: 732
Registered: ‎11-16-2011
Message 3 of 4 (474 Views)

Re: First installation of IMC 5.1 and can't login in the initial page

It's almost certainly a problem with default settings on IE on your server. If IMC is not listed as a trusted site, you will get that behaviour where login appears to fail. 

 

 

This is because the page is not allowed to run scripts by default. 

 

 

Also, make sure you apply SP1 if you haven't already. 

CCIE 36708 | @northlandboy | lkhill.com
Occasional Contributor
akapousi
Posts: 5
Registered: ‎01-18-2013
Message 4 of 4 (471 Views)

Re: First installation of IMC 5.1 and can't login in the initial page

You are right. I fixed it according to your instructions.

 

Thanks a lot both of you guys.

 

Agelos

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.