Re: Round Robin - DSM for MPIO (2711 Views)
Reply
Advisor
Mark Brand
Posts: 27
Registered: ‎08-23-2007
Message 1 of 4 (2,748 Views)
Accepted Solution

Round Robin - DSM for MPIO

I've followed the instructions from the HP P4000 DSM for MPIO Deployement Guide but I am still unable to set the MPIO policy to Round Robin.  Dual nics on the server to a 3 node P4500. Both nics connect up just fine via iSCSI, but when I try to set the MPIO from Vendor Specific to Round Robin, I receive a "The Request is not supported" pop up and I'm not able to change it.  I'm missing something, anyone know why I'm unable to change that. 

Visitor
David R. Urbaniak
Posts: 4
Registered: ‎02-03-2011
Message 2 of 4 (2,718 Views)

Re: Round Robin - DSM for MPIO

Here are the instructions I created and have used to consistently get the MPIO setup to function.  This was done while working with support to get this right since the documentation (as you found) can be a little lacking.

David R. (Dru) Urbaniak
HP Pro
Prakash Singh_1
Posts: 194
Registered: ‎11-25-2010
Message 3 of 4 (2,711 Views)

Re: Round Robin - DSM for MPIO

You can also take a look at the document attached.

 

Regards,

 

Prakash

Regards,

PS
To assign points on this post? Click the white Thumbs up below!
Advisor
Mark Brand
Posts: 27
Registered: ‎08-23-2007
Message 4 of 4 (2,637 Views)

Re: Round Robin - DSM for MPIO

Just in case someone else runs into this problem, I was finally able to upgrade to 9.5 SAN/iQ (from 8.5) and the round robin started working in my iscsi initiators.  Don't know what would've caused this, but just an FYI for anyone else who might run into this and see this thread. 

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.