Re: RAID10 to RAID 5 Configuration Change (219 Views)
Reply
Occasional Visitor
Scott236
Posts: 2
Registered: ‎04-09-2014
Message 1 of 5 (253 Views)

RAID10 to RAID 5 Configuration Change

[ Edited ]

Hello!

 

We have a node with a bad array controller battery and are looking at ways to replace this with the least amount of down time. There are 12 drives, 280GB each setup RAID10. The volumes that will be effected collectively use 105GB configured in RAID10. If we switch them to RAID5 how much additional space will be required on the SAN to accommodate the growth? I looked all over for a conversion chart but had no luck and I suck at math.

 

Thanks!

 

Please use plain text.
Regular Advisor
a_o
Posts: 69
Registered: ‎02-22-2012
Message 2 of 5 (230 Views)

Re: RAID10 to RAID 5 Configuration Change

Too little information.
Please be more specific...model numbers, MG and cluster configuration, etc.
Are these StoreVirtual/P4000 units?
Is this Network RAID or physical RAID you're describing?
Please use plain text.
Occasional Visitor
Scott236
Posts: 2
Registered: ‎04-09-2014
Message 3 of 5 (226 Views)

Re: RAID10 to RAID 5 Configuration Change

Thanks.

 

HP P4500 system with 4 management groups, 4 clusters and 16 nodes using network RAID. One of the nodes has a bad array controller battery. I am thinking I can just convert the volumes effected by the downtime to RAID5, let the data restripe, and carry on but I only have 956GB free on the SAN so I want to make sure its enough to handle the increase if I convert to RAID5.

Please use plain text.
Regular Advisor
a_o
Posts: 69
Registered: ‎02-22-2012
Message 4 of 5 (219 Views)

Re: RAID10 to RAID 5 Configuration Change

Based on this information, it seems that you have 4 nodes per cluster, and also your LUNs are thin provisioned.

If so, it should be OK to do the conversion for the affected LUNs, as you have enough nodes and capacity for this kind of conversion.

 

I would convert one LUN at a time though.

 

I've gotta ask, if you're doing this conversion, are you going to bring down the problematic node?

Or, are you going to  allow your new NR5 LUNs to be striped onto this node?

Please use plain text.
HP Pro
HPstorageTom
Posts: 38
Registered: ‎01-31-2012
Message 5 of 5 (179 Views)

Re: RAID10 to RAID 5 Configuration Change

Be careful with Network RAID 5 - it is only meant for volumes with archive type characteristics: almost only read I/O's and a very, very low write rate to the volume.

 

I am also a bit puzzled why you do need to change the Network RAID level?  It is for sure not due to the bad controller battery. This can be fixed while the StoreVirtual volumes can stay online (bring the node into maintenance mode and replace the bad controller battery).

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation