Signal 11 Error on triggering Close action web service using SOAP UI (923 Views)
Reply
Occasional Advisor
SM_Forum
Posts: 12
Registered: ‎10-31-2011
Message 1 of 3 (923 Views)

Signal 11 Error on triggering Close action web service using SOAP UI

Hello Team,

 

I encounter this error below when I trigger the CloseChange web service using SOAP UI, Could you please assist:

 

<SOAP-ENV:Envelope xmlns:SOAP-ENV="http://schemas.xmlsoap.org/soap/envelope/">
   <SOAP-ENV:Body>
      <SOAP-ENV:Fault>
         <faultcode>SOAP-ENV:Server</faultcode>
         <faultstring>A signal 11 was raised in native code. Client terminated. Error: Win32 Exception: 0xC0000029 (instruction 0x77ED07B6)</faultstring>
         <faultactor>Server</faultactor>
      </SOAP-ENV:Fault>
   </SOAP-ENV:Body>
</SOAP-ENV:Envelope>

Honored Contributor
Abhijit K
Posts: 900
Registered: ‎10-14-2010
Message 2 of 3 (921 Views)

Re: Signal 11 Error on triggering Close action web service using SOAP UI

Hi ,

 

Could you please errors in sm.log file?

 

Re,

Abhijit K

Honored Contributor
-m-
Posts: 989
Registered: ‎02-22-2011
Message 3 of 3 (908 Views)

Re: Signal 11 Error on triggering Close action web service using SOAP UI

A Signal 11 error is a general failure in the RTE/binary layer that can be caused by many things, including: software defect, memory issue, or corrupt/bad data.

 

As Abhijit mentioned, reviewing the sm.log file is the next step as it should contain a stack trace/thread dump related to the error. If the issue can be replicated, consider tracing the action as this will help identify the failure point in the work-flow.

 

Trace parameters:

RTM:3

debugdbquery:999

sqldebug:1

debughttp:1

 

Assuming the cause is not obvious from the log and it is not a published known issue, a ticket should be opened with Customer Support to analyze the trace.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.