Re: Attachment Extension (137 Views)
Reply
Frequent Advisor
abhin88
Posts: 88
Registered: ‎01-07-2013
Message 1 of 2 (166 Views)

Attachment Extension

Hello Experts 

 

I would like to know what is the purpose of the table extensionstate in SM ? 

 

I see some file extension types here and there is an Unsafe check box. I would like to know what is the purpose of this one?

 

 

Abhinav

HP Expert
NgocNgo
Posts: 219
Registered: ‎06-30-2013
Message 2 of 2 (137 Views)

Re: Attachment Extension

Hi Abhinav,

 

Regarding to your question, please find the information as below:

 

The extensionstate table provides the ability to block some document types from being added as attachments and can be extended. Our of box, about 85 file types are blocked. 

 

To view the file extension restrictions, access database manager and enter extentionstate as the tablename. If a file type is not listed as unsafe, then files of that type can be attached.

 

These information are extracted from the old thread: http://h30499.www3.hp.com/t5/HP-Service-Manager-Service/Attachment-File-Types-SM-9-33/m-p/6454732#M1...

 

 

Thank you and Best regards,

HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Also, please assign a Kudo to the post if you find it is helpful
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.