Searching for numbers using document content (170 Views)
Reply
Occasional Contributor
Don_Corleone
Posts: 7
Registered: ‎03-18-2013
Message 1 of 2 (170 Views)

Searching for numbers using document content

Hi everyone

 

I am trying to confirm if TRIM (7.1) is able to search for numbers (numerical charaters) using the Document Content search functionality. It seems that will only search for words or for numbers containing a letter prefix (e.i. X123).

 

Thank you

 

 

Please use plain text.
Honored Contributor
EWillsey
Posts: 1,802
Registered: ‎04-20-2010
Message 2 of 2 (161 Views)

Re: Searching for numbers using document content

It supports it, but it's disable with the default configuration.  To check if it's enabled walk through these steps:

 

1. Open TES

2. Expand Datasets

3. Right-click and select "Event Processing->Configure"

4. For Content Indexing change the status to "Suspended" and then click ok

5. Click Save (Note you don't need to deploy)

6. Right-click and select "Content Index->Properties"

7. Check if "Do not index pure numbers" is checked.  If it is checked, you don't get numbers.  If it is not checked, you do.

8. Click Cancel

9. right-click and select "Event Processing->Configure"

10. For Content Indexing change the status to "Processing" and click ok

11. Click Save

 

If it's disabled, you'll need to enable it.  That will also mean you have to reindex everything.

 

I hope this helps.

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation