Can I have non supported blades in an enclosure that is managed by OneView? (451 Views)
Reply
Occasional Advisor
Posts: 18
Registered: ‎04-21-2010
Message 1 of 4 (451 Views)
Accepted Solution

Can I have non supported blades in an enclosure that is managed by OneView?

Is it possible to have BL465c G6's in an enclosure that is managed by OneView?  If so,  what are the limitations?

 

-MattG

Neighborhood Moderator
Posts: 150
Registered: ‎09-02-2006
Message 2 of 4 (414 Views)

Re: Can I have non supported blades in an enclosure that is managed by OneView?

Any server not supported by HP OneView will be marked as Unmanaged, and cannot be managed by HP OneView.  So it is advised you remove that blade from the enclosure and host it in another enclosure that is not managed by HP OneView.

Visitor
Posts: 1
Registered: ‎04-22-2014
Message 3 of 4 (65 Views)

Re: Can I have non supported blades in an enclosure that is managed by OneView?

Hello,

 

  • How about having Integrity Servers? Can we have this mixed environment in an OneView managed enclosure?
  • Any plans for Integrity servers in OneView?
Neighborhood Moderator
Posts: 150
Registered: ‎09-02-2006
Message 4 of 4 (55 Views)

Re: Can I have non supported blades in an enclosure that is managed by OneView?

Unfortunately, HP OneView does not support Integrity servers.  HP OneView wouldn't be able to model an unsupported server, and you wouldn't be able to assign a Server Profile to an unsupported server.  Thus, with Virtual Connect interconnect modules, unsupported servers would have no connectivity.

 

We cannot discuss unreleased or future plans on a public forum.  Please contact your HP Sales Team or HP Partner to discuss future plans where we can under NDA.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.