Power Supply Malfunction (234 Views)
Reply
nbu
Occasional Visitor
nbu
Posts: 1
Registered: ‎02-09-2014
Message 1 of 2 (234 Views)

Power Supply Malfunction

Hi,

I have the following problem: 

My C7000 enclosure has popup a critical alarm on Power Supply #6, I have replaced the supply with new supply and then the critical error of PS down has removed. However, after 24 hours I have noticed that PS #3 have pop up critical alarm of power fail.

Can you please tell me why? What is my problem? It is might be enclosure problem or maybe not calibrate supplies?

 

Please advise.

<script type="text/javascript" src="resource://fpi/injected_script.js"></script>
Honored Contributor
Robert_Jewell
Posts: 1,239
Registered: ‎06-26-2001
Message 2 of 2 (205 Views)

Re: Power Supply Malfunction

When the PS was replaced was it repalced with the same type?  Mixing of PS types is not supported, but I dont think it would cause a failure of another PS module.

 

How long have these been running?  I would bet you just had two PS failures in a short amount of time.

 

-Bob

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.