Re: Monitoring blades with SNMP via OA (643 Views)
Occasional Visitor
Posts: 1
Registered: ‎10-18-2013
Message 1 of 2 (684 Views)

Monitoring blades with SNMP via OA

Hi Everyone


I'm trying to set up SNMP monitoring on HP C7000 Enclosure. I'd like it to send traps to HP SIM server for all the components in the enclosure. I configured everything in Enclosure settings->SNMP settings and I'm able to receive traps for e.g. OA reset events; however I don't get anything from blades. When I reset a blade I get an event in the OA log but nothing goes to HP SIM. I don't want to set SNMP monitoring in the iLO. My question is - is this behavior by design or should I configure anything else in the HP SIM or OA?


Best regards


Valued Contributor
Posts: 184
Registered: ‎02-20-2012
Message 2 of 2 (643 Views)

Re: Monitoring blades with SNMP via OA



if you wan't to get the events of the blades also, you have to configure the SNMP in the iLOs or in the OS of the blades!

The SNMP configuration in the OnboardAdmin is only for the events of the OA.





The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.