Monitoring blades with SNMP via OA (400 Views)
Reply
Occasional Visitor
geringxes
Posts: 1
Registered: ‎10-18-2013
Message 1 of 2 (400 Views)

Monitoring blades with SNMP via OA

Hi Everyone

 

I'm trying to set up SNMP monitoring on HP C7000 Enclosure. I'd like it to send traps to HP SIM server for all the components in the enclosure. I configured everything in Enclosure settings->SNMP settings and I'm able to receive traps for e.g. OA reset events; however I don't get anything from blades. When I reset a blade I get an event in the OA log but nothing goes to HP SIM. I don't want to set SNMP monitoring in the iLO. My question is - is this behavior by design or should I configure anything else in the HP SIM or OA?

 

Best regards

Krzysztof

Valued Contributor
SwisspostIT
Posts: 181
Registered: ‎02-20-2012
Message 2 of 2 (359 Views)

Re: Monitoring blades with SNMP via OA

Hi,

 

if you wan't to get the events of the blades also, you have to configure the SNMP in the iLOs or in the OS of the blades!

The SNMP configuration in the OnboardAdmin is only for the events of the OA.

 

Regards,

Ville

 

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.