Re: Hp Gen8 and C3000, question about paths (109 Views)
Reply
Occasional Visitor
NetDevel
Posts: 1
Registered: ‎12-15-2013
Message 1 of 2 (148 Views)

Hp Gen8 and C3000, question about paths

I just read the quickspecs of BL420c G8, it says that mezzanine 1 is connected to bays 3&4 and mezzanine 2 is connected to bays 5&6 (or to bays 5,6,7/8 for quad port mezzanines). What does happen when this blade server is used in a c3000? Can I use mezzanine slot2?

 

Thanks in advance.

Please use plain text.
Honored Contributor
Robert_Jewell
Posts: 1,238
Registered: ‎06-26-2001
Message 2 of 2 (109 Views)

Re: Hp Gen8 and C3000, question about paths

You can:

 

  • Mezzanine slot 2 ports 1 and 3 are routed to bay 3
  • Mezzanine slot 2 ports 2 and 4 are routed to bay 4

 

Check out the c3000 Service Manual from this site:

http://h18004.www1.hp.com/products/blades/components/c-class-tech-maintaining.html

 

...and go the section "Interconnect Bay Numbering".

 

-Bob

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation