01-02-2013 12:59 PM
We have a number of HP BL465c G7 blades running ESXi 5.0. They have the NC551i Emulex based flex-10 NIC. Per the HP recommendations earlier this year we updated the drivers to 4.1.334.0.
We're looking at upgrading these to ESXi5.1 with the HP ISO. However, according to the recipe file, and the HP customer advisory C03533196, the recommended BE2Net driver is 18.104.22.168-1. Since the upgrade won't "downgrade" files, to put it at the correct version the workaround is to do a manual VIB install on each blade. The "resolution" section says that "a future release" of the ISO will fix this, but it's been over 2 months and they still haven't fixed it.
According to the advisory, the downgrade is required due to interactions with the fiber channel driver (lpfc) when using FCoE.
However, we're not using FCoE on this interface and have no plans to. We have dedicated QLogic fiber channel card for the SAN communications. The Emulex BE2Net driver is only used for networking.
Since we're not using the Emulex for FCoE, do I still need to downgrade the BE2Net driver?
03-14-2013 04:59 AM
the advisory that you are checking was Last Updated: 2012-10-18
there are some new recipe the last one was released in frebruary and there are new FW/drivers recommendations for your case:
NC551i be2net ESXi 5.0/5.1 - 4.2.327.0 (driver) 4.2.401.6 (FW)
03-14-2013 08:12 AM
Find the advisory on upgrading to ESXi 5.1 (Click here for Document ID: c03533196), which states when upgrading to ESXi 5.1 from earlier ESXi version the be2net driver might not get upgraded and as per the document ESXi 5.1 has inbox driver which is a recommended version.
The present HP recommended version are as below.
NC551i be2net ESXi 5.0/5.1 - 4.2.327.0
NC551i be2iscsi ESXi 5.0/5.1 - 4.2.324.12
NC551i lpfc ESXi 5.0/5.1 - 22.214.171.124.55
Click here for latest HP VMware Recipe Dcoument.
These two drivers are developed and validated as a pair. When the drivers are not in synch, unexpected behavior may be experienced. My personal opinion this applies only when FCoE is configured, otherwise I do not think it should be a problem.
I am an HP employee.
Was the post useful? Click on the white KUDOS! Star on the left side of this post.
For HP Guided Troubleshooting; http://www.hp.com/support/gts
05-31-2013 11:18 AM
was looking for recommended document on firmware and drivers which can be installed on hp proliant servers running vmware operation system
thank you for info
09-25-2013 07:07 AM
Thanks for the reply, does this firmware upgrade is the only firmware update needed for ESXi 5.1 installation on the Blade servers affected ?
or do I need to upgrade the other firmware to be able to proceed ?