08-17-2012 09:03 PM - edited 08-17-2012 09:04 PM
PSOD when adding iSCSI target IP address to BL465c G1 iSCSI NIC
When adding iSCSI target IP address to BL465c G1 iSCSI NIC 0 (the first embedded NIC, it crases wth a PSOD!
I am even using the ISO installation image provided by the link here in the VMware site that is branded an HP version of the ESXi hypervisor.
I also ensure all my firmware and drivers were up to date.
attached is the PSOD...
What could be happening here?
08-21-2012 07:58 PM
Try renaming the vmkiscsid.db file which is at /etc/vmware/vmkiscsid/vmkiscsid.db and reboot the host and configuring it again.
If the issues still exists, it could be a issue with network, cloud you brief on the network configuration.
Was the post useful? Click on the white KUDOS! Star on the left side of this post.
For HP Guided Troubleshooting; http://www.hp.com/support/hpgt
08-21-2012 08:27 PM
What does this file do?
08-23-2012 10:24 PM
The file I had mentioned is the file which holds all the configuration details of the iSCSI on the host, so by renaming the file and rebooting you start configuring from the scratch.
Also on BL465c G1 server onboard NICs I doubt if by default iSCSI is supported, as there was an additional license to enable the same. (I am not sure on this part, but please check with product expert)