the virtual connection flex-10 interconnection configuration change (295 Views)
Reply
Frequent Advisor
singvey
Posts: 78
Registered: ‎07-27-2005
Message 1 of 3 (295 Views)

the virtual connection flex-10 interconnection configuration change

[ Edited ]

we have two hp c7k blade systems.  when we removed the vc flex-10 interconnect modules from the c7k chassis, we forgot to mark which c7k chassis  they were removed from.  what will happen if we install the vc flex-10 interconnect modules into the wrong c7k chassis?

 

1-each chassis will maintain its original vc configuration

2- the configuration of the vc on the chassis will be swapped

3- both chassis will default to factory default settings.

4-POST will issue a warning that the wrong vc modules are inserted .

 

 

P.S. This thread has been moved from HP BladeSystem > Virtualization to HP BladeSystem Virtual Connect. - Hp Forum Moderator

Respected Contributor
Psychonaut
Posts: 214
Registered: ‎08-31-2011
Message 2 of 3 (280 Views)

Re: the virtual connection flex-10 interconnection configuration change

Assuming that the domain is only these two VC's (and that the chassis are not stacked); #2 is what should happen.  

 

 

Super Advisor
albertwt
Posts: 327
Registered: ‎01-20-2011
Message 3 of 3 (34 Views)

Re: the virtual connection flex-10 interconnection configuration change

So how did you finally end up with the solution or the situation ?

 

please share it here :-)

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.