Re: Virtual Connect (VC)Flex-10/C7000 Question (169 Views)
Reply
Neighborhood Admin
chuckk281
Posts: 3,179
Registered: ‎01-09-2007
Message 1 of 3 (262 Views)

Virtual Connect (VC)Flex-10/C7000 Question

John had a customer question:

 

************

 

Have a customer that has the below question:

 

 

Current environment: c7000, 4 bl460c G6 blades, FC HBA in Mezz 1, Flex-10 NIC in Mezz 2.  GbE2c Interconnect Modules in Bays 1,2,5,6 and Brocade FC Module in bays 3 and 4.

 

Customer wants to use the Flex capabilities on the NIC in Mezz 2, so can a Flex-10 module be put in bays 5 and 6.  Existing modules in bays 1,2,3,4 will remain.

 

************

 

Reply from Dale:

 

************

 

A couple of comments.  The Flex-10 interconnects have been discontinued and has been replaced by the Flex-10/10D.  There is no requirement for placement of a pair of Flex modules within a c7000 (since FW v3.10), but with the requirement of GbE2 modules in Bays 1 & 2 and Brocade modules in Bays 3 & 4, there may be caveats and FW minimums that are needed.

 

***********

 

Also from Mark:

 

**************

 

Regardless if you use Flex-10 or Flex-10/10D, the architecture is the same.

 

Virtual Connect does not care about the modules in Bay 1/2 and 3/4, as long as the I/O matches to the Mezz/NIC, it will be allowed. VC 3.10 removed the requirement that the Primary/Backup module be installed in Bay 1/2.

This is allowed and VC does not manage the Brocade FC module or the GBe2c modules so there is no relationship between versions of VC Firmware matched with non-VC modules firmware.

The Server profiles will show unassigned for Port 1 and 2 (maps to NULL) while Port 3-10 will map to the 8 Logical Functions of a 554M (flex).

VC will only write CLP for 554M, not 554FLB since it is connected to GBe2c.

 

 

 

webpic296.jpg

 

*************

 

Questions?

 

Regular Visitor
geoarchitect
Posts: 4
Registered: ‎06-07-2013
Message 2 of 3 (209 Views)

Re: Virtual Connect (VC)Flex-10/C7000 Question

We had to initally start with Pass-Thru approach for our Networking and Storage.  We are now adding virtual connect for the networking side.   From your information, sounds like I can install the virtual connect Flex-10/10D modules on interconnect bays 5-6 or 7-8 and retain pass-thru in bay 1-2.    We would then transition servers to virtual connect as we define and apply the profiles.

 

Do we need to shutdown entire C7000 enclosure to add the new interconnect modules?

 

Occasional Visitor
Ashwin1120
Posts: 1
Registered: ‎08-20-2014
Message 3 of 3 (169 Views)

Re: Virtual Connect (VC)Flex-10/C7000 Question

Hi Chuck,
Can you tell me How to view the CLP output as you showed in the orginal post?

Thanks

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.