Troubleshooting Vmnic Link Failure Proliant BL460c G7 Hypervisor ESXi5.5 (192 Views)
Reply
Frequent Visitor
Kumi Chetty
Posts: 2
Registered: ‎01-21-2008
Message 1 of 2 (192 Views)

Troubleshooting Vmnic Link Failure Proliant BL460c G7 Hypervisor ESXi5.5

I had a situation where one of the VMINC's serving the management console had come up in a failed state after reboot.

Customer Environment is C7000 chassis with VC Flex 10 intercconects. Now all the other VSwicthes in the cluster were fine so I had a strong suspicion this was a nuisance failure. A reboot would have most probably fixed tis problem ,however the host in question was hosting a Storevirtual- so not an ideal situation to shutdown disk to fix such a trivial fault.

 

I decided to find an alternative way to fix the fault, attached is a detailed process to identify and fix such a fault.

Frequent Advisor
marcelkoedijk
Posts: 45
Registered: ‎05-29-2007
Message 2 of 2 (166 Views)

Re: Troubleshooting Vmnic Link Failure Proliant BL460c G7 Hypervisor ESXi5.5

Are you able to check de Virtual Connect LogFile. Login to the VCM WebGUI and look at te logfile in the left colum.

If there is a link swapping on this logfile you have to look at VC or the external switch.

 

Be sure that the recommended firmware and drivers are loaded.

http://vibsdepot.hp.com/hpq/recipes/HP-VMware-Recipe.pdf

 

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.