Can't enable VLAN Tunnel (854 Views)
Reply
Highlighted
Occasional Visitor
Posts: 1
Registered: ‎07-30-2013
Message 1 of 3 (854 Views)

Can't enable VLAN Tunnel

I am trying to modify our existing config to add VLAN tunneling to our networks, however the checkbox is now greyed out. I'm assuming its because uplinks or servers are assigned but just wanted to make sure what I need to do to enable this.

Trusted Contributor
Posts: 279
Registered: ‎10-07-2010
Message 2 of 3 (823 Views)

Re: Can't enable VLAN Tunnel

To enable Tunnel you need to start fresh.

You cannot enable Tunneling on a Network that is part of an SUS.
A Tunnel talks to the uplinks directly and doesn't use SUS.

Any reason you are trying to enable Tunneling? Flex-10/FlexFabric with 3.30 or higher now support 1000 Networks in the Domain and 162 per Physical port (so 162 WITH redundancy)
Advisor
Posts: 21
Registered: ‎08-19-2009
Message 3 of 3 (51 Views)

Re: Can't enable VLAN Tunnel

To enable trunk you need to do as below:

1. Remove this network from all the blade /template profiles

2. Edit the netowrk now you will see VLAN tunneling active you can enable.

 

I use this type of direct link which is teunked in switch site fro esx host so that you will not tagg VLAN in host profile, only ading VLAN to vSphere distributed switch can work

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.