Blade servers connected to Pass-Thru and Flex-Fabric modules at same time (137 Views)
Reply
Occasional Contributor
DavoudTeimouri
Posts: 6
Registered: ‎04-25-2013
Message 1 of 1 (137 Views)

Blade servers connected to Pass-Thru and Flex-Fabric modules at same time

Hi dears,

 

We are using two pass-thru modules on each enclosure for storage connectivity, I have a plan for change them with Flex-Fabric modules.

Pass-Thru modules are installed on Bay 3 and Bay 5 and each BL460c G6 server has two HBA adapters on mezzanine 1 and 2. CNA adapters are installed on our G7 servers (Mezzanine 2) and they are powered off.

I want to replace one of pass-thru modules with a Flex-Fabric and keep other pass-thru module for some days. Because I need to test modules and new CNA cards on some other servers.
Is it possible working G6 servers with a HBA card and pass-thru and test other servers with CNA cards and flex-fabric modules?

 

My enclosure overview

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.