Allocated Bandwidth Change (152 Views)
Occasional Visitor
Posts: 1
Registered: ‎12-19-2013
Message 1 of 2 (152 Views)

Allocated Bandwidth Change

Hi, I have a need to make a change to allocated bandwidth to several ethernet adapters on a flex fabric module.  Question is, if I make these changes, will it cause any loss of (temporary) connectivity?


If there is a loss of connectivity, I'm assuming I won't see it because I'm using 2 VC modules?  See attached for my current setup.  Bascially, I want to take port 1 and 2 and change the allocated bandwidth to 1 GB.



Respected Contributor
Posts: 214
Registered: ‎08-31-2011
Message 2 of 2 (94 Views)

Re: Allocated Bandwidth Change

Nope, no loss.  Although it occurs to me that some OS's may not handle it as well - what are you running?  I'd say if it's a relatively current OS and your drivers/firmware are not completely out of date you should be good to go.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.