HP 10GbE Pass-Thru isci (142 Views)
Reply
Occasional Visitor
rsa_sean
Posts: 1
Registered: ‎02-21-2013
Message 1 of 2 (142 Views)

HP 10GbE Pass-Thru isci

I have "Inherited" a C3000 Blade chasis that has 2 ProLiant BL460c G6 and 4 ProLiant WS460c G6 Blade Workstation. 

 

The chasis also has a  HP 10GbE Pass-Thru Module. 

 

I was looking at the configurations while trying to trouble shoot a vlan trunk issue, I am wondering if the group could possibly shed some light on my issue. 

 

Here is my issue: I am trunking 2 vlans from a cisco switch to blade slot one Nic 1(interface 1 on the interconnect module) and then a standard connection connection to the switch port on slot one Nic 2 (interface 9 on interconnect) 

 

Nic 2 is only needed because it is connected to compellant SAN using iscsi connection. While poking around I noticed that the HP OA reports that there is an iscsi port mapping when I look at the device bay port mapping in table view.

 

Port 1 OK Bay 1 Port 1 AA:AA:AA:AA:AA:11
iSCSI Port 1 OK Bay 1 Port 1 AA:AA:AA:AA:AA:22
Port 2 OK Bay 1 Port 9 BB:BB:BB:BB:BB:44
iSCSI Port 2 OK Bay 1 Port 9 BB:BB:BB:BB:BB:55

 

 

is there a way to leverage this iscsi connection ?

 

Thanks

Please use plain text.
Neighborhood Moderator
Jeroen_Kleen
Posts: 119
Registered: ‎04-29-2003
Message 2 of 2 (100 Views)

Re: HP 10GbE Pass-Thru isci

Hello, the BL460c uses the 553i chipset where you can use it for iSCSI as well; each NIC port as 2 MAC's 1 for network traffic and a seperate one for doing the iSCSI traffic. You can easily use and configure that if needed; keep however in mind that we only support software based iSCSI accellaration and not HW based like we do with later G7/Gen8 platform.

Cheers, jeroen

 

(I am an HP Employee and CI Ambassador)
http://www.hp.com/go/hpCloud
http//www.hp.com/go/CI
http://www.hp.com/go/OneView
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation