Re: Checking the License on Blade SAN Switch (673 Views)
Reply
Neighborhood Admin
chuckk281
Posts: 3,223
Registered: ‎01-09-2007
Message 1 of 2 (1,109 Views)

Checking the License on Blade SAN Switch

Sally had a customer question:

 

*****************************

 

How to check the license on Blade SAN Switch? We need to upgrade blade enclosure and not knowing if Blade SAN Switch are 8/12 or 8/24.

 

******************************

 

Terri had a way:

 

****************************

 

From the Brocade cli (command line) run the following command:

 

Licenseshow (not case-sensitive)

 

If you see a 12-port license installed, it is a 8/24. If you see no port licenses installed, it is a 8/12.

 

***********************************

 

That should help Sally. Any other methods that you use?

Occasional Advisor
Abderrazak
Posts: 8
Registered: ‎04-03-2012
Message 2 of 2 (673 Views)

Re: Checking the License on Blade SAN Switch

Hello ,

I need Help .

 

I have just install SAN switch HP B-series 8/12c BladeSystem SAN Switch on C3000 with only one server blad and when I configure and accesss to the SAN swich you see the attached word fike I see only twi port Active 17 and 18 the rest not active is this still need a license or just need install blad server with HBA card ????

 

 

and I need to knw what is mean What is " 8 Gig FC license" stand for ? on licenseshow

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.