Re: VLANs - Cisco Catalyst Blade Switch 3020 for HP (83 Views)
Reply
Occasional Visitor
david_pol
Posts: 3
Registered: ‎03-19-2014
Message 1 of 3 (147 Views)

VLANs - Cisco Catalyst Blade Switch 3020 for HP

HI,

 

I'm new to the Cisco Catalyst Blade Switch 3020 for HP. How do you assign 1 port to more than 1 VLAN? On the older GB22c switch I enabled tagging and could assign a port to multiple VLANs. I can'f find the cisco way to do this.

 

Thanks.

Please use plain text.
Honored Contributor
Cederberg
Posts: 551
Registered: ‎07-03-2007
Message 2 of 3 (105 Views)

Re: VLANs - Cisco Catalyst Blade Switch 3020 for HP

The cisco way to use more than one VLAN per port is called trunking.

 

There is a chapter in this document that describe it indepth. The chapter is called "Configuring VLAN Trunks" and if you just want the commands search for "Configuring a Trunk Port".

 

http://www.cisco.com/c/en/us/td/docs/switches/blades/3020/software/release/12-2_55_se/configuration/...

Please use plain text.
Occasional Visitor
david_pol
Posts: 3
Registered: ‎03-19-2014
Message 3 of 3 (83 Views)

Re: VLANs - Cisco Catalyst Blade Switch 3020 for HP

Thanks for the the last post. So I setup my vlans, and the 2 ports connected to the blades are set to 802.1Q trunk. I have set the "trunks allowed" to the 2 vlans.  Problem is - I can only ping from the port I set the "Native VLAN" to.  I attached a picture. any ideas?

 

Thanks,

 

Dave

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation