BL460c CNA and Linux (290 Views)
Reply
Collector
EricDuncan
Posts: 2
Registered: ‎02-20-2014
Message 1 of 3 (290 Views)

BL460c CNA and Linux

I have a BL460c with a HP FlexFabric 10Gb 2-Port 534FLB Adapter running RHEL 5.10. Everything is working great but SAN connectivity. How do you get this to see the CNA as a FC HBA? I came close to getting the FcoE drivers to work but a no go. Can someone assist or point me in the correct direction?

 

Thanks!

HP Pro
Vijayasarathy
Posts: 270
Registered: ‎01-10-2012
Message 2 of 3 (265 Views)

Re: BL460c CNA and Linux

 

If Virtual Connect module is not installed, then run RBSU by rebooting the server and pressing the F9 key during boot prompt. Under menu System Options > NIC Personality Options > Select the controller and then press ‘enter’ key to list the personality choices and then choose FCoE to set personality for FC connectivity.

 

If Virtual Connect module is installed, then the profile settings take precedence and hence make the settings in Virtual Connect Manager (VCM) or Virtual Connect Enterprise Manager (VCEM).

 

Regards,

 

Vijayasarathy

I am an HP employee.


To say thanks click the "thumbs up" icon below!!!
Collector
EricDuncan
Posts: 2
Registered: ‎02-20-2014
Message 3 of 3 (262 Views)

Re: BL460c CNA and Linux

The profile looks correct. It has the network and HBA's set with WWN's. I checked to see if the BIOS had that option and it does not. What else can I check?

 

Thanks

 

Eric

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.