Add Vlan to Uplink port (300 Views)
Reply
Occasional Contributor
Vip1982
Posts: 1
Registered: ‎05-26-2013
Message 1 of 2 (300 Views)

Add Vlan to Uplink port

We need to add a VLAN to an uplink. We are not sure if this port is acting as a trunk or access. If we go to the VLAN and add that uplink port to it, would it change the status of the uplink (like from trunk to access), because I don't want to lose connectivity to the whole enclosure.

 

 

Switch model : HP 1:10Gb Ethernet Blade Switch.

BladeSystem c7000 Enclosure G2

Advisor
Joaragon
Posts: 22
Registered: ‎05-16-2013
Message 2 of 2 (276 Views)

Re: Add Vlan to Uplink port

The VC will always act as a Trunk, it can be in one of 2 modes mapped mode ( where you decide what adapter the vlan is mapped to ) and tunneled mode where it just tunnels whatever your switch is presenting. If you're just adding a Vlan in mapped mode you won't have an outage and shouldn't need a reboot as long as your server profile has assigned "empty" NICS. If you need to add a NIC to the profile the server needs a reboot to take the new adapter.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.