Re: GSP telnet access (148 Views)
Reply
Occasional Advisor
Paul Clark_3
Posts: 12
Registered: ‎03-19-2002
Message 1 of 3 (148 Views)
Accepted Solution

GSP telnet access

Dear All,

I have a problem logging into GSP using Telnet.
There is a screen shot of the message I'm getting in the word document attached.

Does anyone know what can be causing this, as I can connect to the log-in screen but after that it goes a bit funny.

Many thanks in advance

Paul
The Joy of HP-UX ain't nothing like it!
Please use plain text.
Honored Contributor
John Palmer
Posts: 1,842
Registered: ‎07-28-1997
Message 2 of 3 (148 Views)

Re: GSP telnet access

Hi,

This is the normal response when you log in.

Just do what it says, type Control/E then c then f and you will get console access.

Regards,
John
Please use plain text.
Valued Contributor
Juan Manuel López
Posts: 234
Registered: ‎03-07-2001
Message 3 of 3 (148 Views)

Re: GSP telnet access

Yes, Your have to type " Ecf " to get the GSP prompt.
Once you are inside GSP, use " help list " to get the command list.
If you have to logout, use " co " to get the normal unix login.
I hope this help you.

Juanma.
I would like to be lie on a beautiful beach spending my life doing nothing, so someboby has to make this job.
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation