GSP telnet access (203 Views)
Occasional Advisor
Posts: 12
Registered: ‎03-19-2002
Message 1 of 3 (203 Views)
Accepted Solution

GSP telnet access

Dear All,

I have a problem logging into GSP using Telnet.
There is a screen shot of the message I'm getting in the word document attached.

Does anyone know what can be causing this, as I can connect to the log-in screen but after that it goes a bit funny.

Many thanks in advance

The Joy of HP-UX ain't nothing like it!
Honored Contributor
Posts: 1,842
Registered: ‎07-28-1997
Message 2 of 3 (203 Views)

Re: GSP telnet access


This is the normal response when you log in.

Just do what it says, type Control/E then c then f and you will get console access.

Valued Contributor
Posts: 234
Registered: ‎03-07-2001
Message 3 of 3 (203 Views)

Re: GSP telnet access

Yes, Your have to type " Ecf " to get the GSP prompt.
Once you are inside GSP, use " help list " to get the command list.
If you have to logout, use " co " to get the normal unix login.
I hope this help you.

I would like to be lie on a beautiful beach spending my life doing nothing, so someboby has to make this job.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.