GSP Commands - N Class Server (606 Views)
Reply
Occasional Contributor
Simon Wootton
Posts: 5
Registered: ‎12-16-1999
Message 1 of 2 (606 Views)

GSP Commands - N Class Server

Can anyone provide me with a list of commands available within GSP on the
N-Class, or point me in the right direction ?
Occasional Advisor
Marcio Duarte_1
Posts: 5
Registered: ‎02-13-2000
Message 2 of 2 (606 Views)

Re: GSP Commands - N Class Server

GSP> he
HE

Hardware Revision X Firmware Revision A.XX.XX July 16 1999, 17:19:31

AC: Alert delay configuration
PC: Remote power control
AR: Config. automatic system restart
PS: Power management module status
CA: Confiure serial port parameters
RP: Rest password configuration
CE: Log repair info in history buffer
RS: System reset through RST signal
CO: Return to console mode
SE: Activate a system session
DC: Default configuration
SL: Display SPU status log
DI: Disconnect remote or LAN console
SO: Security options & access control
DR: Disable remote or LAN console
SS: System Processor status
ER: Enable remote or LAN console
TC: System reset through INIT signal
HE: Display the available commands
TE: Send a message to other terminals
IT: Modify GSP inactivity timeouts
VFP: Activates alert log display
LC: Configure LAN console
WHO: Display a list of GSP connected users
LS: Display LAN console status
XD: GSP diagnostics and reset
MR: Modem reset
XU: Upgrade the GSP firmware


Where: X is the current hardware revision, and A.XX.XX is the current firmware
revision.

Regards!

Marcio
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.