Re: CE's replaced failed disk last week. Now "showpd" doesn't show disk at all ! (1088 Views)
Reply
Frequent Advisor
Posts: 52
Registered: ‎10-06-2011
Message 1 of 6 (1,091 Views)
Accepted Solution

CE's replaced failed disk last week. Now "showpd" doesn't show disk at all !

Has this happened to anybody else?  We assumed that the PD was rebuilding or something, but it's been a week.  Do we have to do anything?  Did our CE make a mistake?  BTW, this has happened TWICE, once on one array, once on another array.

 

     Stuart

Frequent Advisor
Posts: 52
Registered: ‎10-06-2011
Message 2 of 6 (1,090 Views)

Re: CE's replaced failed disk last week. Now "showpd" doesn't show disk at all !

These Arrays are HP 3PARs.
Highlighted
HP Pro
Posts: 8
Registered: ‎07-12-2013
Message 3 of 6 (1,088 Views)

Re: CE's replaced failed disk last week. Now "showpd" doesn't show disk at all !

The replaced drive will have a different PD Id. So if you are looking for the original PD ID you will not see it.

Can you confirm if you can see any other PD in the same location as the failed PD?

I work for HP
Acclaimed Contributor
Posts: 23,943
Registered: ‎10-02-2001
Message 4 of 6 (1,083 Views)

Re: CE's replaced failed disk last week. Now "showpd" doesn't show disk at all !

If a disk has been replaced, let's say PDID 99, the replacement disk will get the next available PDID, let's say 199.

Same will happen when the next disk will be replaced, but then the next free ID will be 99 again.

After all data is restored to the new disk, the system will do a "dismisspd", so the old PDID will disappear.

Hope this helps!
Regards
Torsten.

__________________________________________________

There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________

No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Frequent Advisor
Posts: 52
Registered: ‎10-06-2011
Message 5 of 6 (1,068 Views)

Re: CE's replaced failed disk last week. Now "showpd" doesn't show disk at all !

You are absolutely correct.  Both of you.  We found the disks (PDs) with different PD-IDs.  Who would have thought!

 

     Stuart

Acclaimed Contributor
Posts: 26,031
Registered: ‎03-06-2006
Message 6 of 6 (1,061 Views)

Re: CEs replaced failed disk last week. Now showpd doesn't show disk at all

If you do a "showpd -i" you can match up the WWN with the drive labels.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.