Re: UPS Management modules? (520 Views)
Occasional Contributor
Posts: 6
Registered: ‎06-10-2013
Message 1 of 2 (575 Views)

UPS Management modules?

[ Edited ]

Sorry if this is the wrong forum.


Looking for help configuring out AF401A management modules for our UPS. I can't seem to connect to the module through the configuration port.


Connected config port to computer via usb-serial converter.


Using 115200 bits

8 data bit

parity none

stop bits 1

flow control none


Using Putty to connect. Push reset button. Seems to connect but we never see a post to continue with configuration.


Any help would be appreciated.





P.S. This thread has been moved from ProCurve-ProVision-Based to Servers > general. -HP Forum Moderator

HP Pro
Posts: 134
Registered: ‎08-23-2011
Message 2 of 2 (520 Views)

Re: UPS Management modules?



Following are the stesp required to enter HP UPS Management Module Service Menu

  1. Connect a network cable in the "Config-PassThru" port on the UPS Management Module, and the other end to a server or laptop, with a RJ45 to DB9 serial converter.(Check the steps for connecting configuration cable on Page 21 of the user guide @
  2. Run HyperTerminal or any other console emulation software (like PuTTY).
  3. Press the RESET button on the UPS Management Module.
  4. On the session screen, the POST executes, and then a prompt appears. Press any key within 5 seconds to enter the HP UPS Management Module Service Menu.
Thanks & regards,
I work for HP
A quick resolution to technical issues for your HP Enterprise products is just a click away HP Support Center Knowledge-base
See Self Help Post for more details
Was the post useful? Say thanks by clicking the white KUDOS Star!

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.