Time drift (396 Views)
Reply
Occasional Contributor
at coetsee_1
Posts: 5
Registered: ‎10-11-2005
Message 1 of 7 (396 Views)

Time drift

Out client have 2 x HP ML370G4 X3.4 2MB Hi Perf EU Rack Srvr with
384954-B21 RHEL 4 AS Std
Both systems gain about 10 minutes per hour.
Where do I start looking for the problem ?
Honored Contributor
Ivan Ferreira
Posts: 6,957
Registered: ‎05-07-2004
Message 2 of 7 (396 Views)

Re: Time drift

Are you using NTP? Are your timezone correctly configured? Check your BIOS time and ensure that the /etc/sysconfig/clock, ZONE UTC and ARC settings are correct.
Por que hacerlo dificil si es posible hacerlo facil? - Why do it the hard way, when you can do it the easy way?
Occasional Contributor
at coetsee_1
Posts: 5
Registered: ‎10-11-2005
Message 3 of 7 (396 Views)

Re: Time drift

Thank you. The site is in Tanzania and I am in South Africa. It will take about 18 hours to get tried, so hopefully by to-morrow night I will know.
They claim that they are not using NTP, but I was not on site during installation
Frequent Advisor
Steve_160
Posts: 63
Registered: ‎08-18-2002
Message 4 of 7 (396 Views)

Re: Time drift

I think what Ivan is trying to say is that you SHOULD be running ntpd.

Check the man pages on ntpd and ntpdate. In a nutshell, here are the commands I call from a cronjob to set the time. Note that ntpd has to be stopped before running netdate.

killall ntpd
/usr/sbin/ntpdate -B pool.ntp.org
/usr/sbin/ntpd
hwclock --systohc

At bootup, "-b" should be used instead of "-B." You don't want to change the slew based on a free-running hardware clock.



#@%!! Windows!
Honored Contributor
Vitaly Karasik_1
Posts: 1,461
Registered: ‎10-22-2002
Message 5 of 7 (396 Views)

Re: Time drift

does linux run under VMWARE?

If no, it may be problem with BIOS clock/drivers.
Even running NTP is a good idea, I'll suggest to investigate drift problem anyway.
Respected Contributor
BUPA IS
Posts: 236
Registered: ‎10-14-1997
Message 6 of 7 (396 Views)

Re: Time drift

I concur ntp is the way forward. You may find that tock.nml.CSIR.co.za gives you a better ntp response than the global pool for your Tanzanian location It is fed by the CSIR atomic clocks in Pretoria which are part of the UTC aggregation .

http://www.csir.co.za/plsql/ptl0002/PTL0002_PGE100_LOOSE_CONTENT?LOOSE_PAGE_NO=7330214
Mike
Help is out there always!!!!!
Frequent Visitor
Gudufl
Posts: 3
Registered: ‎09-13-2011
Message 7 of 7 (390 Views)

Re: Time drift

I now that the earlier posts are years ago, never the less I am experiancing a "time drift" too.

I and using ntp and the tock.... CSIR time server too on a HP ServerTower ProLiant ML350 G6, QC Xeon E5620(2.40GHz)

12MB, 8 x SFF, P410i/256MB, 6GB(3x2GB), 460W PSU, DVD-ROM using VMware ESX, 4.1.0, 320092 and am experiancing a once of 10min time drift that only appears when the server has to sync the time with the CSIR time server after a reboot of the VMware host. Any suggestions?

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.