02-10-2010 09:43 AM
Basically When I reset the card and push a button to inturupt the boot process, I am presented with 3 options, 1 configure card, 2 UPS-Pass Through, 3 Exit. When I push 2 the screen just sits there and says entering pass-through mode. Is there a trick to making this work? Thanks.
Solved! Go to Solution.
02-11-2010 08:39 AM
I guess you see the Overview Meter wrongly report as a 3-phase UPS?
First, upgrade the FW of UPS R3000XR (make sure not a R/T3000) to FW= 2.02(once select option 2, the Config Port on the card will act as a serial port of the UPS, the UPS FW flash utility would communicate directly to UPS) or you can use the built-in serial port on UPS to flash the UPS (9600,8,n,1,none)
If your card has an old FW=1.20 then the lastest HPMM FW= 2.1.3, you can flash via the Config Port (as is, not set to Pass-Through) or via Network port.
Caution; both flash utilities are not the same!
Find them here:
02-11-2010 08:47 AM
02-11-2010 01:02 PM